One-shot LED Trigger¶
This is a LED trigger useful for signaling the user of an event where there are no clear trap points to put standard led-on and led-off settings. Using this trigger, the application needs only to signal the trigger when an event has happened, then the trigger turns the LED on and then keeps it off for a specified amount of time.
This trigger is meant to be usable both for sporadic and dense events. In the first case, the trigger produces a clear single controlled blink for each event, while in the latter it keeps blinking at constant rate, as to signal that the events are arriving continuously.
A one-shot LED only stays in a constant state when there are no events. An additional "invert" property specifies if the LED has to stay off (normal) or on (inverted) when not rearmed.
The trigger can be activated from user space on led class devices as shown below:
echo oneshot > trigger
This adds sysfs attributes to the LED that are documented in: Documentation/ABI/testing/sysfs-class-led-trigger-oneshot
Example use-case: network devices, initialization:
echo oneshot > trigger # set trigger for this led
echo 33 > delay_on # blink at 1 / (33 + 33) Hz on continuous traffic
echo 33 > delay_off
interface goes up:
echo 1 > invert # set led as normally-on, turn the led on
echo 1 > shot # led starts blinking, ignored if already blinking
interface goes down:
echo 0 > invert # set led as normally-off, turn the led off